GWY-700 Operations

GWY-700 reads and writes RFID tags and converts the data so it can be used with a PLC or computer. This Gateway has one serial port for field communications and programming. The port supports RS232, 485, and 422 at baud rates up to 115 k.  It has a built-in antenna and operates with standard RFID tags with a 13.56 MHz frequency. With the internal antenna, the sensing distance is approximately 80 mm. Our Windows based Gateway setup software makes it easy to configure the RFID protocol converter. Using a simple spreadsheet format, the user decides which registers should be mapped to the RFID data fields. Reading or writing to the tag is secured and reliable using authentication and encryption. In addition, the Gateway offers very high data integrity check while transferring the data to the tag. Powerful software features allow you to have all of the information transfers done continuously or under PLC control registers. System requirements for Gateway Setup Software are: Programming software is common for the entire Gateway family.     Windows Version   : Microsoft Windows 9x/NT/2000/XP Processor             : PENTIUM or higher Hard disk Space    : 5 MB or more Mouse                  : Required RAM                     : 16 MB or more Display resolution  : 800 X 600 (VGA) or better Display colors       : 16 bit color  Other Accessories required for the GWY-700 configuration and to use in actual application: 1. Gateway Configuration / Connecting Cable. 2. Gateway Setup Software . 3. Devices with communication cables. GWY-700 communication ports: The GWY-700 has one communication port, PLC1 / COM1. This port is compatible to RS232 / RS422 / RS485 and CMOS signal levels. The Pin-outs of this port is as shown below:               *Do not use pin no. 6 of either of the GWY-700 communication ports.