GWY-600 is a Serial to Ethernet transparent Gateway.
GWY-610 is a Protocol Converter / Data sharer for devices like PLCs, Inverters, Controllers etc. GWY-610 has a serial port, that connects to a serial device and a Ethernet port(Modbus TCP Client, Modbus TCP Server and other Ethernet Protocols), that connects to Ethernet. This Gateway allows serial devices to act as a server on to a Modbus TCP/IP network. It also allows serial devices to act as a Client on to a Modbus TCP/IP network.
Our Windows® based Gateway setup software makes it easy to configure the GWY-610 and GWY-620. After choosing which protocol to be used for each port, you can program the Gateway to transfer the data blocks. The same software can be used to download HTML pages to a GWY-620 to make it a HTML server.
System requirements for Gateway Setup Software are:
Programming software is common for the entire Gateway family.
Windows Version : Microsoft Windows 9x/NT/2000/XP
Processor
: PENTIUM or higher
Hard disk Space : 5 MB or more
Mouse
: Required
RAM
: 16 MB or more
Display resolution : 800 X 600 (VGA) or better
Display colors : 16 bit color
Other Accessories required for the GWY-600 configuration and to use in actual application:
1. Gateway Configuration / Connecting Cable.
2. Gateway Setup Software .
3. Devices with communication cables.
Communication ports:
The GWY-6XX PLC1 / COM1 port is compatible to RS232 / RS422 / RS485 and CMOS signal levels. Passthrough port supports RS232 signal levels. The Pin-outs of these ports are shown below:
|
